To pour epoxy "crystals" into CB pipes:

1. go to OTB 14 and get the charge to transfer
2: remove 5' extensions and connectors
3. upend base to clean out debris, water, etc.
4. when clean and dry, charge pipes and base
5. replace quartz crystals if desired 
6. jazz up the orgone levels by putting power graphics under the CB, 
   wands driving into the CB, HHGs against it, on top of base, etc.
7. pour pure polyester or epoxy into holes
   however much you feel is right
   not too much at once (heat)

One could submerge the base almost to the top of the pipes in charged water,
for cooling as well as charging. If convenient.

I haven't done this, but strongly suspect it would rock.
And it should be easily doable by the average orgonite hobbyist.